Galley sink + drainer in S/Steel , size is for boat or RV (reduced)

The Orca Auto 1300 is the new addition to the IC bilge range of intelligently controlled pumps from Whale. The compact and powerful automatic Orca Auto 1300 requires no additional field sensor or float switch rather they are integrated within the pump to ensure the most effective automatic bilge water removal. The submersible pump has a large footprint ensuring lowest water level detection and maximum surface area exposure to bilge water. High performance - 1300 gallon / hour flow rate (82 Litre / min) Simple to install-built in Automatic sensor - no need to fit a separate bilge switch Efficient - large filter- maximum surface area exposed to bilge water Solid state switching - no moving parts Long battery life - low amp draw Neat fit in compact bilge areas Unaffected by wave motion Brand new , unopened in original packaging . Bargain

Hubbell Shore Power Plug 30A 125V High quality stainless marine shore power plug 2 Pole 3 Wire. Protected to IP56. As new in original packet .Was 1000 baht now reduced to 700 baht

Exhaust anti-siphon loop and breaker valve kit supplied with hose tails for a complete hose line anti-siphon installation. This kit is supplied with the following parts to create a working anti-siphon device: 1 x brass loop with two 3/4" BSPF ports and one 1/2" BSPF port (410014) 1 x brass siphon valve with one 1/2" BSPM and one 3/8" BSPF port (410043) 2 x brass 3/4" BSPM to 19mm hose tails (404045) Once assembled, these give a complete anti-siphon device suitable for 19mm hose lines and a 10mm vent hose. This will only allow water to flow in the intended direction and will create a vacuum if the flow is reversed. Typical installations for an anti-siphon device are sea water intakes, exhaust injection lines and toilet systems where the equipment installed is below the waterline. Hose Tail Size 19mm / 3/4" Country of Origin Italy With Valve Yes Construction Brass bend and hosetails. Valve is brass with a rubber valve Hose Size Suits ID: 19mm (3/4") (with (3/8") connection for vent line) Solid brass 2250 baht each ( one sold ,one available, now reduced to clear)

Aqua Signal nav-switch is an ingenious multi-switch for clear and fault-free operation of navigation-, deck- and instrument lighting. An easy to install solution for safety on board. The Nav-Switch can be placed anywhere on the boat, for example on the steering station, where decisions are made. The respectively prescribed navigation lighting for moving under sail power (the sail symbol), or if the boat is under way, motor driven (the propeller symbol) or when at anchor (the anchor symbol) can be directly altered using the switch. The instrument lighting is also switched on at the same time as the navigation lighting. A function lighting (eg., deck illumination) can be switched on or off in every switch position by pulling on or pressing on the Nav-Switch. Protection Degree -IP66 Mounting -Recessed mounting Electric 12 Vdc or 24 Vdc Brand new in original packaging ( now reduced to clear )